SOP for Cleaning of Disintegration Test Apparatus
1.0 OBJECTIVE
To lay down for procedure for cleaning of disintegration test apparatus.
2.0 SCOPE
This procedure is applicable for all disintegration test apparatus, installed at quality control laboratory.
[ads id="ads1"]
3.0 RESPONSIBILITY
3.1 Doing : Technical Assistant
3.2 Checking : Technical Assistant /Executive
4.0 ACCOUNTABILITY
Head of the Department
[ads id="ads1"]
5.0 PROCEDURE
5.1 Switch ‘OFF’ the instrument.
5.2 Switch ‘OFF’ the Main.
5.3 For Cleaning of Assembly
Frequency : After every test
5.3.1 On completion of every disintegration test, remove the beakers and assembly along with discs.
5.3.2 Wash them properly with purified water and keep aside.
[ads id="ads1"]
5.3.3 Record in the log card of instrument .
5.4 For Water bath
Frequency : Once in a week
5.4.1 Switch ‘off’ the instrument.
5.4.2 Remove the external probe from water bath.
5.4.3 Remove beakers along with the assembly from water bath of the disintegration test apparatus.
5.4.4 Remove the lid and heater electrical connector from water bath.
5.4.5 Remove the water bath and discard water from it into respective container.
5.4.6 Wash the water bath with raw water, detergent solution and then with raw water until no foam of detergent remain in the bath. After complete removal of all detergent, wash the bath with purified water.
5.4.7 Clean the external surface with wet cotton cloth and finally clean with lint free cloth.
[ads id="ads1"]
5.4.8 Place the water bath on its original place.
5.4.9 Fill the water bath with purified water upto the level indicated on the external surface of the water bath.
5.5 After cleaning of the disintegration test apparatus, record it as per Annexure-I.
N.B.: In between when water become dirty change water as per step.No.5.4.
[ads id="ads1"]
6.0 ABBREVIATIONS
6.1 SOP - Standard Operating Procedure
6.2 R.O. Water - Reverse Osmosis Water
[ads id="ads1"]